Frequently Asked Question

How do I Set up Brother HL-L6200DW(T) for EMA and AirPrint
Last Updated 9 years ago

  1. Connect printer to wired network and navigate to ip for configuration
  2. Go to Administrator | Firmware Update
  3. Check for new firmware and install both updates, one after the other. If firmware fails to install at this point, use the Brother Status Monitor on the key computer for that printer
  4. General | Contact & Location and type a friendly Location name (i.e. - DERM NURSE STATION 03)
  5. On printers with second tray, go to Print | Tray and set Tray Priority to MP>T1>T2
  6. Network | Protocol | AirPrint | Advanced Settings and set friendly Printer Name (i.e. - BR_DERMNURSE03)
  7. Network | Wireless | Node Name (Wireless) and enter same name as the AirPrint Printer Name (i.e. - BR_DERMNURSE03)
  8. Network | Wireless | Wireless (Setup Wizard), start wizard and follow instructions (disconnect Ethernet cable when applying settings and wait for a confirmation page)
  9. Network | Network | Interface and select wireless interface only (i.e. - NC-8500w, IEEE 802.11b/g/n)
  10. Network | Wireless | IPv6 (Wireless) and enable
  11. Test and deploy printer (when installing Brother driver on a PC, choose "custom" and install the driver only unless the Status Monitor is needed to upgrade the firmware)

Please Wait!

Please wait... it will take a second!